![reset eprom epson 1410 adjustment program reset eprom epson 1410 adjustment program](https://taosif.com/wp-content/uploads/2020/11/Stylus-Photo-TX650-resetter-150x150.png)
When the counter of the amount of waste ink, presumably drained into the sump, reaches the value preset in the printer's control program, the printer first displays a warning about the imminent end of the life of the absorbent pad, and soon completely blocks the ability to send a print job. Since the volume of ink pumped out of the head during cleaning procedures is approximately known, and the capacity of the sump is also known, it is not difficult to calculate when it is full. In reality, this system is nothing more than a program counter that counts the number of times the printer is turned on and all head cleaning procedures are performed.
![reset eprom epson 1410 adjustment program reset eprom epson 1410 adjustment program](https://rankingintensive298.weebly.com/uploads/1/2/3/8/123886231/968392947.jpg)
To avoid such an extremely unpleasant situation, absolutely all inkjet printers are equipped with a waste ink control system. Since the volume of the container for collecting ink, with the absorber located in it, has a certain limitation, sooner or later, there comes a time when the containers overflow, and ink begins to flow out, which becomes the cause of contamination of the printer itself and everything that surrounds it. Also, when starting regular cleanings through the printer driver, ink is pumped from the cartridges through the print head into the absorber. Where does waste ink come from in an inkjet printer? Each time it is turned on, the print head is automatically cleaned - a small amount of ink is pumped from the cartridges into the print head, which at this moment is in the extreme right (left) position of the printer, and the ink is “dumped” into the “diaper”. This "diaper" is a container in which there is an absorbent material that absorbs waste ink well. In all inkjet printers, a special container is used to collect waste ink (Waste Ink), which is often called a "pampers". Moreover, a warning about the imminent end of the service life of the absorbent lining (diaper) also pops up as a system message on the computer monitor.Īfter the warning message appears, you have the opportunity to print another 15-20 images (photos) of A4 format, after which the printer will refuse to print, until the waste ink counter is reset. blinking of two red LEDs under the printer buttons, and also pops up an error window on the computer monitor. "With the active operation of an inkjet printer, there comes a moment when the printer refuses to work and gives an error message, with a request to contact the service center.